| Production
Speed: |
 1-30
loads per hour
NOTE: Process rates will vary with load size,
number of
wraps & forklift load/unload
time |
 |
| Load Capacity: |
Maximum
load weight: 4,000# dynamic – 10,000#
static
Maximum load size: 56” W x 56” L
x 80” H (79” Max.
load diagonal) |
|
Turntable:
(for dual turntables) |
48” Octagonal,
5/16” thick, formed steel
4 point caster support system
Turntable height less than 11” from
floor
ANSI # 50 Direct Chain Drive c/w Chain
tensioner
3-15 RPM rotational speed c/w soft
start acceleration
1/2 HP DC Drive Motor
Final Revolution Deceleration and
positive stop alignment
Front and back forklift ports for
easy movement
Accu-Count exact turntable positioning
system for
additional film savings! |
|
| Film Carriage Elevator: |
1/2
HP DC variable speed motor
ANSI #40 direct chain drive c/w shock
dampener
Maintenance free 12 point carriage
guidance system |
|
| Film Delivery System: |
Rapid
Thread™ 20” capacity pre-stretch
film carriage
1/2 HP DC variable speed motor
Fully electronic dynamic dancer corner
compensation
33 to 313% fixed stretch capability
Pre-stretch ratio variable by easy
sprocket change
Rapid Thread™ (Safety Door) with auto
power cut-off
switch
Carriage
descent obstruction shut-off device for additional
safety
Side mounted film carriage for operator
convenience and
safety |
|
| Control Features: |
Simple
to operate
PANASONIC PLC
Power Off – On – Reset
Switch & Power
On Indicator
Light
Single button Auto Wrap Cycle Start/Pause
Cycle pause for applying top sheets
Base or top wraps first program
Reinforce wrap control for mid-wrapping
Up only or up/down wrap program
Emergency Stop Button
Turntable Jog Button
Film Carriage Lower/Raise Switch
Film Tension (Force-to-Load) Control
Separate Film Carriage Raise & Lower
Speed Controls
Variable Turntable Speed Control
Automatic Load Height Detection Sensor
Separate 1 to 9 Revolution Top & Bottom
Wrap Control
NEMA 12 Enclosure
Non-proprietary UL/CSA approved components |
|
| Structural Features: |
All
structural steel construction
Forklift truck portable base structure
design – lifting
tubes
included for front and rear access
Structural steel H-beam machine tower
Electro-static powder coated paint
finish |
|
Electrical Requirement:
|
115
Volts 1 Phase 60 Hz 15 Amps |
