| Production
Speed: |
 1-35
loads per hour
NOTE: Process rates will vary with load size,
number of wraps & load/unload time |
 |
| Load Capacity: |
Maximum
load weight: Unlimited – Floor loaded
Maximum load size: 50” W x 50” L
x 86” H (71” max.
load diagonal)
Minimum load size: 30” W x 30” L
x 24” H |
|
| Rotary Arm: |
Double
flange bearing support system
Twin V-belt drive pulleys with belt
tensioner
1-12 RPM rotational speed c/w soft
start acceleration and
positive stop alignment
1/2 HP DC rotary arm drive motor |
|
| Film Carriage Elevator: |
1/2
HP DC variable speed motor
Direct flat belt drive system
Maintenance free 12 point carriage
guidance system |
|
| Film Delivery System: |
Rapid
Thread™ 20” capacity pre-stretch
film carriage
1/2 HP DC variable speed motor
Fully electronic dynamic dancer corner
compensation
110 to 313% fixed stretch capability
(shipped fixed at
250%)
Pre-stretch ratio variable by easy
sprocket change
Rapid Thread™ (Safety Door) with auto
power cut-off
switch |
|
| Control Features: |
PANASONIC PLC with Touchscreen Operator Interface
Power Off – On – Reset
Switch & Power
On Indicator
Light
Single button Auto Wrap Cycle Start/Pause
Cycle Pause for applying top sheets
Reinforce wrap control for mid-wrapping
Emergency Stop Button
Turntable Jog Button
Film Carriage Lower/Raise Buttons
Film Clamp Open/Close Button
Film Tension (Force-to-Load) Control
Selectable Reduced Bottom Film Force
parameter for
wrapping bottom of load
Separate Film Carriage Raise & Lower
Speed controls
Variable Rotary Arm Speed Control
Triple Beam Automatic Load Height
Detection sensor for
dark or shiny loads
Separate 1 to 12 Revolution Top & Bottom
wrap control
Broken film/out of film detection
c/w automatic machine
reset
Stack-light beacon indicates run,
clear or fault
Remote pendant start switch
Rotary arm and film carriage elevator
dynamic braking
system
NEMA 12 control panel and junction
boxes
Dust tight slip ring assembly
Non-proprietary UL/CSA approved component |
|
| Automation Features: |
“All Electric – No
Pneumatics Required”
Electro-mechanically actuated film
clamp mechanism
Electro-mechanically actuated film
tail cut/wiper arm
mechanism
Ni-chrome impulse hot wire film cut
off c/w automatic
periodic cleaning cycle |
|
| Structural Features: |
All
structural steel construction
Integral structural steel wall/floor
mounting stand
Electro-static powder coated paint
finish |
|
| Safety Features: |
Personnel safety – rotary
arm obstruction emergency
stop sensor |
|
Electrical Requirement:
|
115
Volts 1 Phase 60 Hz 15 Amps |
