| Production
Speed: |
 1-40
loads per hour (Dual Turntable)
NOTE: Process rates will vary with load size,
number of wraps & forklift load/unload
time |
 |
| Load Capacity: |
Maximum
load weight: 5,000# dynamic – 12,000#
static
Maximum load size: 56” W x 56” L
x 80” H (79” Max.
load diagonal) |
|
| Turntables: |
48” Octagonal,
5/16” thick, formed steel plate (qty.
2 for
dual turntable)
4 point caster support system
Turntable height less than 11” from
floor
ANSI # 50 Direct Chain Drive c/w tensioner
3-15 RPM rotational speed c/w soft
start acceleration
3/4 HP DC Drive Motor (qty. 2 for
dual turntable)
Final Revolution Deceleration and
positive stop alignment
Front & back forklift ports for
easy movement
Accu-Count exact turntable positioning
system for
additional film savings!
|
|
| Film Carriage Elevator: |
1/2
HP DC variable speed motor
Belt/Pulley with Anti-Fall Device
Maintenance free 12 point carriage
guidance system |
|
| Film Delivery System: |
Rapid
Thread™ 20” capacity pre-stretch
film carriage
1/2 HP DC variable speed motor
Fully electronic dynamic dancer corner
compensation
33 to 313% fixed stretch capability
Pre-stretch ratio variable by easy
sprocket change
Rapid Thread™ (Safety Door) with auto
power cut-off
switch
Carriage descent obstruction shut-off
device for additional
safety
Side mounted film carriage for operator
convenience and
safety |
|
| Control Features: |
Simple
to operate
PANASONIC PLC with Touchscreen Operator Interface
Power Off – On – Reset
Switch & Power
On Indicator
Light
Single button Auto Wrap Cycle Start/Pause
Cycle Pause for applying top sheets
Base or top wraps first program
Reinforce wrap control for mid-wrapping
Up only or up/down wrap program
Emergency Stop Button
Turntable Jog Button
Turntable Left/Right Switch (dual
turntable systems only)
Film Carriage Lower/Raise Buttons
Film Tension (Force-to-Load) Control
Separate Film Carriage Raise & Lower
Speed Controls
Variable Turntable Speed Control
Triple Beam Automatic Load Height
Detection Sensor for
dark or shiny loads
(2 sensors
provided with dual
turntable system)
Separate 1 to 12 Revolution Top & Bottom
Wrap Control
NEMA 12 Enclosure
Non-proprietary UL/CSA approved components |
|
| Structural Features: |
All
structural steel construction
Forklift truck portable base structure
design – lifting
tubes
included for front and rear access
Structural steel tube machine tower
c/w sheet metal
covers
Electro-static powder coated paint
finish |
|
Electrical Requirement:
|
115
Volts 1 Phase 60 Hz 20 Amps |
